• Alison Hodge
    151
    While checking a couple of towers when we were planning to start ringing after the Covid restrictions were relaxed, we noticed that a surprising amount of stone dust and debris had collected on the top arcs of the bell wheels. We brushed this off before ringing to prevent it working into the ropes.

    Has this been noticed elsewhere?

    The spiders have also been very busy but i am sure that they have had a great 18months undisturbed in many towers!
  • Paul Tucker
    4
    My routine check list for the tower at St Tudy in Cornwall does not include looking at the top of the wheels for debris so I will add it to the list. My first thought was that as soon as the bell is rung debris would fall off. However, during the winter when the tower is damp, debris could stick to the top of the wheel.
    Paul Tucker, St Tudy, Cornwall
  • John Harrison
    436
    it will depend on the tower. Whatever normally accumulates in the bell chamber will settle on any surface undisturbed for a long time. In our case it's blown dust and pigeon down but we have a wooden roof above the bells. If there was a sandstone spire above then stone dust would be in the mix.
  • Samuel Nankervis
    21
    Dust does come off the walls, and settles on the bell frame too. This dust can then attract moisture when it's damp, which isn't good, so a general dust/clean off once/yr. could be beneficial.
  • John de Overa
    490
    Our spire is empty above the bells and the wind tends to spiral inside and dislodge anything loose from the stonework. Before the rehang we had literally inches of stone dust and dirt on the floor under the bells. Apart from the damp it traps, it can also get inside pulley bearings - our old ones were rubbish anyway, but where destroyed by grit ingress. About every 6 months or so I vacuum all of it up.
  • Susan Hall
    14
    Our sandstone broach spire rises directly above the bells. During lockdown spiders made webs over the bells and fittings, which caught the falling stone dust. We use a vacuum cleaner to remove the stone dust and webs (to avoid sweeping and causing dust clouds). We also 'sweep' the stone stairs by vacuuming.
bold
italic
underline
strike
code
quote
ulist
image
url
mention
reveal
youtube
tweet
Add a Comment

Welcome to your Ringing Forums!

If you would like to join in the conversation, please register for an account.

You will only be able to post and/or comment once you have confirmed your email address and been approved by an Admin.